Hold down the Command-key while the cursor is above a column divider. When the cursor changes drag to resize columns.
Command-Option-click to reset the column to its default position.
You cannot set the start-up drive to the selected device because it is not a disc or it is the current start-up drive (indicated by a gray underline).
Click here to set the start-up drive to the selected ID.
This command is not supported when running A/UX
This item represents your Macintosh which has permanently assigned SCSI-IDツ 7.
Click here or type 窶廾窶 to select the way Mt.ツ Everything窶冱 commands will work.
The button is dimmed because normally only disk-drives have implemented the Start/Stop-Unit command. The selected device is not a disk.
This command is not supported when running A/UX
Click here to start or stop the SCSI-Diskdrive currently selected.
Click the 窶廾ptions窶ヲ窶-button to select how this command works.
This is the currently selected SCSI-Device. Its ID is displayed on the left side.
The 窶廬nfo窶, 窶彜tart/Stop窶 and 窶廴ount窶 commands below will work on this device.
This line is dimmed because Mt.ツ Everyting could not find a device with that ID either because there is none connected or because the device failed to respond.
Try 窶弑pdate窶 in the latter case.
Click here to select the SCSI-Device having the ID displayed on the left.
The 窶廬nfo窶-, 窶彜tart/Stop窶- and 窶廴ount窶-commands below will only work on the selected device.
Command-click here to see a list of Mac volumes on the device (if it窶冱 a disk).
Mount volumes from a SCSI-Disk.
The button is disabled because you do not have a disk selected.
Click here or type 窶廴窶 to mount all Volumes found on the selected disk.
Option-click to reinstall a fresh copy of the disk driver (either the one loaded from the disk or Mt.ツ Everything窶冱 built-in driver).
Click here or type 窶弑窶掖o rescan the SCSI-Bus and update the displayed information.
Option-click or type 窶廾ption-R窶 to reset the entire bus (e.g. if you have switched a device窶冱 SCSI-ID).
Displays information on the selected SCSI-Disk.
The button is dimmed because the device currently selected is not a disk.
Click here or type 窶廬窶 to get information on the selected SCSI-Disk.